What Size Stove Rope Do I Need

Here’s everything you need to know about What Size Stove Rope Do I Need. Find all the information it in this article.

If you can slide the paper back out without tearing it when the door is closed, your existing rope stove is not doing its job properly and should be replaced. Drop-in stoves are less common than freestanding, slide-in, and apartment sized stoves. They are small stoves installed on top of a base cabinet, which brings them up to the standard countertop height of 36 inches. Therefore it is important that the air-tightness of any door seal is regularly checked. The standard stove size for freestanding ranges is 36″ tall by 30″ wide by 26″ deep.

Keep an eye out for one or more of the following warn signs that indicate it’s time to replace your wood stove. You just need to pull out enough to configure the width of the channel with a ruler or tape measure . Measure across the channel and record your measurement. Carefully remove any cement or adhesive residue that may remain in the channel. Of the stove glass and its gasket and to replace the gasket if necessary.

Check The Stove Door Rope Seal Is Still Air

A professional range may be 36″ or even 48″ wide. Fire rope, or what is sometimes called ceramic stove rope, comes in a range of different sizes and it is always important to make sure you use the right size of ceramic fire rope for your stove. You can either measure the width of the channel that holds your stove rope or measure the width of the fire rope itself. The diameter is the width, in a straight line, between the widest points in the stove rope when it is not compressed or stretched. 1/2″ low, medium and high density gasket are night and day as far as sealing ability goes. You need to find out which one belongs in your stove. Or, try to find 5/8″ medium density.

Please get in touch with us for a free, no-obligation quotation – the ADS team is always here to help. This is how your stove rope pack will arrive, with two metres of your chosen rope, a tube of high-temperature silicone adhesive ideal for stove doors and full fitting instructions. Visit our Rope Kits section to browse our rope kits today. There is also a seal or glass gasket on your stove, this will either be rope or self-adhesive flat seal.

Door Gasket Size

Measure your rope by feeding it around the channel – try not to stretch or compress it, and then cut the required length, allowing an extra 2 or 3mm to take up any slack in the joint. When you are satisfied you have the correct length rope seal use heat resistant tape to tape around both ends of the rope to prevent them from fraying. Slide in ranges that have front controls and no backguard will typically be close to 36.5″ tall and are also usually 30″ wide.

One of the problems you will come across is that as rope is a woven product when you cut it it tends to fray. The way round the problem is with high-temperature end rope tape. Put a couple of wraps of tape around the end of the rope, cut off the excess and then cut through the end of the tape for a nice clean joint and professional finish. This is the most common type of stove in the United States, and if you haven’t remodeled, this is likely what you have in your kitchen right now.

How Often Should You Change Fire Bricks In A Wood Stove?

On the other hand, standard rope has a much tighter weave that can feel like squeezing your finger. The first thing that you should do is to tease the rope away from the stove. To do this, when the stove is cold, open the door and you will see the rope running around the edge. Over time, the rope can become squashed so once you have removed it, form it back into a round shape.

However, should you notice that it is drawing more fiercely than normal or that there are tar deposits beginning to build up, it could be a sign that the rope could need replacing. Do you know what size rope you need for your stove? This is one of the most frequently asked questions from our customers, so to help you we have taken a closer look at how you can work out the size that you need. The correct answer is to install a new 6″ chimney. 1.5kw per radiator so, using our Stove Search, you would need to be looking for boiler stoves with dedicated output to water of at least 27kw.

How Do I Stop My Stove Rope From Fraying?

Where the paper can be loosely moved around or easily slides out then it is obvious that the door rope seal needs to be replaced. If the stove has a double door then all of the seals should be replaced at the same time. Established in 2002, we are leading suppliers of spare parts for wood-burning stoves, including glass, firebricks, rope, seals, clips, paint, baffle plates and more. With workshop facilities on site, we also carry out all types of stove door repairs in-house. Once you have spent some time to consider what size of stove to buy you can then look through our range of wood burning stoves that will best suit you.

The control panel adds a few inches to the overall height, which can be up to 46″ tall including the control panel. Dual fuel ranges use gas to power the cooktop and electricity to power the oven. Color options are usually white, black, or stainless steel. Drop-in stoves have a smaller oven capacity than freestanding or slide-in stoves, usually around 3 to 4 cubic feet. Apartment sized stoves can be much taller than 36 inches if the control panel is located on the back of the stove. If you’re remodeling or designing a custom kitchen, slide-in stoves are worth considering because they offer a higher-end look than freestanding ranges.

How Do You Install Rope Seals?

To get a better idea of what heat output you will need from a wood burning stove you can use our heat output calculator. You should remember that this is only a guide as factors such as how well insulated your room is etc will affect the output that is needed. The standard drop-in cooktop stove size is 26″ to 28″ tall, 30″ wide, and 26″ deep. Instead of a raised rear control panel, slide-in models have their controls in front. Slide-in stoves can have induction ranges, gas ranges, electric ranges, or duel fuel ranges. The standard slide-in stove size is 36″ tall, 30″ wide, and 26″ to 29″ deep.

Although older slide-ins commonly had a rim around the cooktop that overlapped the countertop on either side for a built-in look, this feature is less common today among mainstream appliance brands. Old slide-ins also used to be shallower than the typical countertop and required a filler piece behind the cooktop. Today, many slide-ins are full-depth (so around 25-28″) and don’t require this filler piece. The Hunter 14 is the biggest in the Herald series – it has a big output of 12-16kw & like the other models it is available as a wood burning stove or a multi fuel model. The multi fuel model will burn wood as well as coal & smokeless fuel & has a riddling grate – riddled by an external riddling handle.

Rope Seal For Stoves

It is compact and thin (5/8 inch), offering an unobtrusive view of the flames through the glass. Ensure that you have bought the correct diameter rope seal by checking in your stove handbook or directly with the stove manufacturer. If it’s too small then you’re back to square one and if it’s too large you could put excessive pressure on the door hinges or door handle locking mechanism causing them to either warp or break. You will also need the appropriate heat resistant rope seal glue and heat resistant joining tape. The easiest way to do this is to wait until the stove is cold and tear some writing paper or magazine into strips of about 50mm (2″) wide. Position the first strip above the top hinge, between the door and the stove bodywork, then close the door and try to remove the paper strip by pulling it out.

How Do You Measure A Stove Rope?

If the stove has a 6” flue collar, then you should use 6” stove pipe and 6” chimney pipe through the roof. If your stove has a 8” flue collar then you run 8” stove pipe all the way up. Gasket material used to be made from asbestos, but now it is made from various densities and sizes of glass fibre. Most rope seal gaskets are from 3mm to 20mm thick. In some cases the gasket is cut to length from a reel, and sometimes it comes pre-cut in a kit with the cement you need to hold the rope seal in place.

Q What Size Stove Pipe Should I Install In My Wood Stove?

Freestanding ranges can have different heating elements and sources, with induction ranges, natural gas ranges, electric ranges, and dual fuel ranges available. Drop-in stoves are different from drop-in cooktops, which don’t have an oven under the cooktop range. Drop-in cooktops are typically found in kitchens with wall ovens.

Stratford Stove Rope

How To Cut A Wood Stove Gasket With the old gasket and cement removed, lay the new gasket within the stove door groove. Start the gasket in the middle of the door on the side which has the hinges on. Cut the end of the gasket where it meets the start. Stovax has a selection of rope seals and insulation tapes to choose from. If you would like to find a specific rope for your Stovax appliance, please visit

You need to replace the stove rope when it is no longer forming a seal between the door and the stove body. The rope may stop sealing correctly if it becomes squashed, broken or frayed. Some of those you will be able to determine by simply look at the rope. Another way to check the rope seal is to trap a piece of paper in your stove door.

Ceramic cord is much more resistant to high temperatures (up to 1260°C or 2300°F) and hot flushes (up to 1800°C or 3272°F). Sometimes it may be necessary to degrease the surface using a solvent like white spirit. If you rub the surfaces to be bonded with a light abrasive, this will help to give a good key. Read our guide; How to write a stove analysis guide first.